[Gasification] Which engine design might be BEST for woodgas?
Greg Manning
a31ford at gmail.com
Sat Aug 13 17:36:43 CDT 2011
Toby,
I aggree with you, the only reason for the electronic version was the cost
of the re-machine of a sutable "plug" of steel to replace the pump with, as
to mount the distributor in.
Greg
On Sat, Aug 13, 2011 at 5:22 PM, Toby Seiler <seilertechco at yahoo.com> wrote:
> GF and Greg,
>
> Is the gear on the pump useable to make a distributor turn? It would not
> be some odd gear ratio since it controls timing of the injectors. Hopefully
> a 2/1 ratio.
>
> A point to CDI conversion of my Mitsubishi fork lift engine (4 cyl) cost
> around $80. Why not take a 4 cylinder distributor and adapt it to fit where
> the gear driven injector pump is located. I'll bet you could even use the
> pump gear if you can get placement right, which is most likely in the center
> as opposed to offset.
>
> Regards,
>
> Toby
> Seilertechco
>
> _______________________________________________
> Gasification mailing list
>
> to Send a Message to the list, use the email address
> Gasification at bioenergylists.org
>
> to UNSUBSCRIBE or Change your List Settings use the web page
>
> http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
>
> for more Gasifiers, News and Information see our web site:
> http://gasifiers.bioenergylists.org/
>
>
--
Regards,
Greg Manning,
Brandon, Manitoba, Canada
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.bioenergylists.org/pipermail/gasification_lists.bioenergylists.org/attachments/20110813/c6880cb7/attachment.html>
More information about the Gasification
mailing list