[Gasification] Best use for liquid hydrocarbons?

[phillip manske]

Hi, If you have a formula for cutting bio oil for use in boiler burners and
a burner approved for 200 psi steam boilers, please let me know.

Phillip

On Thu, Sep 15, 2011 at 12:46 PM, <Carefreeland at aol.com> wrote:

> **
>  In a message dated 9/15/2011 12:36:04 P.M. Eastern Daylight Time,
> edge_mark at hotmail.com writes:
>
> Hello all,
>
> Long time reader, first time poster.
>
>  I am planning on building a small gasifier to run an IC engine for
> electricity and heat.
>
> About 3/4 of my available energy is in the form of chipped forest waste and
> the balance is waste oil.
>
>
>
> If possible I would like to add the waste oil to a downdraft gasifier for
> drying and cracking.
>
> Has this been tried and were the results favorable or would I be wasting my
> time.
>
> My thought was to control oil flow by utilizing a vacuum pump from the
> engine.
>
>
>
> Obviously I could use the waste oil in a separate burner, but that would
> seem to be unnecessary, perhaps not.
>
> Any thoughts would be greatly appreciated.
>
>
>
> edge
>
>  Mark,
>     Filter the oil,mix it with diesel, and burn it in a diesel motor.
> Also, soak the oil into the wood chips and burn them for heat.
>
>     Dan Dimiduk
>
> _______________________________________________
> Gasification mailing list
>
> to Send a Message to the list, use the email address
> Gasification at bioenergylists.org
>
> to UNSUBSCRIBE or Change your List Settings use the web page
>
> http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
>
> for more Gasifiers,  News and Information see our web site:
> http://gasifiers.bioenergylists.org/
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.bioenergylists.org/pipermail/gasification_lists.bioenergylists.org/attachments/20110915/36618583/attachment.html>