[Gasification] Need help from gasifier experts_Clinker formation
Prasad Mande
prasad.mande at Agnienergy.com
Thu Jul 26 07:04:51 CDT 2012
Thank you Jeff. I don't think I can alter much in the gasifier which is standard design by IISc. With little modifications such as in flow rate or ash removal can I expect some change?
-----Original Message-----
From: gasification-bounces at lists.bioenergylists.org [mailto:gasification-bounces at lists.bioenergylists.org] On Behalf Of Jeff Davis
Sent: Thursday, July 26, 2012 7:04 AM
To: Discussion of biomass pyrolysis and gasification
Subject: Re: [Gasification] Need help from gasifier experts_Clinker formation
On Mon, 2012-07-23 at 23:42 -0700, Prasad Mande wrote:
> Clinkers are primarily due to the temperature in the reactor bed which
> is exceeding probably ash fusion temperatures for the biomass pellets
> I used. I want to know from you the ways to control this reactor bed
> temperature inside gasifier, such that I can avoid clinker formation
> and also reduce the temperature
Dear Prasad,
You could lower the draft. Possibly some kind of injection like steam or engine exhaust.
One possibility would be to run in a slagging mode. In other words keep the slag at a high temperature so that it is in a liquid state until it is out of harms way. But that might not be possible with a down draft.
NOT an expert,
Jeff
--
________________________________________________
www.puffergas.com
Sent from any port in the storm via Acer netbook & Ubuntu Remix.
_______________________________________________
Gasification mailing list
to Send a Message to the list, use the email address Gasification at bioenergylists.org
to UNSUBSCRIBE or Change your List Settings use the web page http://lists.bioenergylists.org/mailman/listinfo/gasification_lists.bioenergylists.org
for more Gasifiers, News and Information see our web site:
http://gasifiers.bioenergylists.org/
More information about the Gasification
mailing list