[Greenbuilding] Thin High R-value insulation for exterior
Lynelle Hamilton
lynelle at lahamilton.com
Sat Oct 30 08:28:38 CDT 2010
Hi All:
Again, I turn to this list for advice.
My house is durisol block, but I want to add 12-15R insulation to the
exterior, in part to reduce heat loss from the webs of the block, and
partially because I want R40-R43 walls.
I have reclaimed 3" SM Board (blue EPS) to put on the outside of the
durisol.
The facing is manufactured stone. I have had 3 masons look at the
property. One mason says no problem attaching the stone to the durisol
through the 3" EPS, the other two say well.,....can't you find something
else? They point to the possibility that the screws needed will bend
in the EPS, allowing the block to sag.
Both say spray on closed cell insulation provides too uneven a surface
to attach lath and stone.
So, has anyone done what I'm doing? What was the result? Alternately,
does anyone know of anything with grater rigidity than the EPS, perhaps
with higher R-value per inch, that would work?
Please don't point me to the engineer....he says this is out of his scope.
Many, many thanks!
Lynelle
--
Effective immediately, please use the following e-mail address to reach
me: lynelle at lahamilton.com
More information about the Greenbuilding
mailing list