[Greenbuilding] finally found some mesh/netting/fabric

[Reuben Deumling]

to stretch over open stud bays before blowing cellulose into them. My
question for the brain trust is how you keep this stuff snug up against the
studs, so no cellulose can force itself between the mesh and the studs,
which would interfere with subsequent attempts to hang drywall?
On the stuff I used previously (I think it was recommended by someone here)
the hole size was 1/4" square and I stapled it to the studs and then rolled
glue up and down the stud faces *through* the holes. That method worked
o.k. But this stuff is more like a hospital gown. I wonder if the glue
would work its way through the tiny holes to adhere the stuff to the stud
faces?
I'm open to all suggestions.
Mostly I'm looking forward to a lot less blowback with this stuff!

Thanks.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.bioenergylists.org/pipermail/greenbuilding_lists.bioenergylists.org/attachments/20161213/ffdd4706/attachment.html>