<table cellspacing="0" cellpadding="0" border="0" ><tr><td valign="top" style="font: inherit;">Hello all, <br><br>I have a insulation retrofit question for a 150 year old timber frame house in the hudson valley, ny.<br><br>I am redoing the trim in a bedroom and found a previous re-modeler had; removed all wall finish material, insulated the 4" thick timberframe wall with fiberglass, plastic over that then framed a 2x2" ish wall in front and then gwb. <br>The 2x2 wall is spaced an inch or two from the timber frame in many places and is open.<br><br>The room is a bedroom with a vapor barrier underlayment and carpet floor over a first floor kitchen .<br><br>I would like to fill all of the cavities with cellulose.  <br><br>My question is, should I remove the plastic before insulating?  I fear the 2-4" of cellulose will allow enough moisture to reach the plastic and condense.  <br><br>The problem with having the plastic removal being required
 for insulation installation is not all of the plastic is accessible without a more invasive strategy.  The strategy would involve wall board removal and this isn't really part of the scope.  <br><br>So, will 3 or 4 inches of cellulose allow the rh to increase enough at the plastic in winter to condense?  figure 70 degrees F and 30% RH.<br><br>Thank you in advance for your help.<br>Tom <br><br>"Time makes more converts than reason."  Thomas Paine, Common Sense</td></tr></table><br>