<br><div class="gmail_quote"><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;"><div><div><div><div class="h5"><div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">
<div style="word-wrap: break-word;"><div><div><div><div><blockquote type="cite"><div><br></div><div><br><div class="gmail_quote">On Fri, Apr 29, 2011 at 7:34 AM, jfstraube <span dir="ltr"><<a href="mailto:jfstraube@gmail.com" target="_blank">jfstraube@gmail.com</a>></span> wrote:<br>


<blockquote class="gmail_quote" style="margin: 0pt 0pt 0pt 0.8ex; border-left: 1px solid rgb(204, 204, 204); padding-left: 1ex;">I am not near by: Waterloo and Boston.<br>
If you look at at the article by Betsy Petit in the retrofit of a 1916 Sears Roebuck house, you will see one approach we have used numerous times.<br>
strip to board, drill holes and densepack with cellulose, IR scan to confirm all cavities full, Tyvek Drainwrap taped and seal (as air barrier and secondary drainage plane), special care at mudsill and roof with tapes and foam, then two staggered layers of foam insulation, outer layer taped (as primary drainage plane), 1x3 screwed to nominal 1" sheathing boards, cladding.  I think TimberLok are too big and I know that we dont need them: we use them because they are locally available in the 6-10" lengths we need.  For other project we order roofing screws from commercial roofing supply stores.<br>



<br>
You would be "safe" with just 1.5" of polyiso over 2x4 with cellulose, but I would recommend more, two, 1.5" layers would mean you are done for the next 100 years.<br>
<br>
The larsen truss on the exterior requires more care and effort to get good performance, because foam plastics are air impermeable, non-hygroscopic, and vapor semi-impermeable: using cellulose as exterior insulation is a completely different animal and requires better care and control of air flow control, reverse water vapor drive (particularuly with shingle cladding) etc.  Is, has, and can be done, but lots more things that have and do go wrong.<br>



<br></blockquote></div></div></blockquote></div></div></div></div></div></blockquote></div></div></div></div></div></div></blockquote></div><br>John-<br>What's your assessment of the impact of thermal bridging, comparing the larsen system and the 2 layers of polyiso?<br>
AA <br>