<html>
  <head>
    <meta content="text/html; charset=windows-1252"
      http-equiv="Content-Type">
  </head>
  <body bgcolor="#FFFFFF" text="#000000">
    <div class="moz-cite-prefix"><font face="Helvetica, Arial,
        sans-serif">OK Gennaro, I'll bite.  <br>
        1. What size of overhang does PH recommend to provide shading </font>of
      a window on Sept 15 in NYC<br>
      2. What happens to the heat that enters the window and "has
      nowhere to go" in a thermos (or PH)?  <br>
      <br>
      <div class="moz-signature">Dr John Straube, P.Eng. <br>
        <a class="moz-txt-link-abbreviated" href="http://www.BuildingScience.com">www.BuildingScience.com</a></div>
      On 12-08-15 4:35 PM, Gennaro Brooks-Church - Eco Brooklyn wrote:<br>
    </div>
    <blockquote
cite="mid:CAPV9BxNcs2b4U0U0jsZ-HeNGaMLgCOmuQgrBNXc_pY4JGo7ORg@mail.gmail.com"
      type="cite">
      <pre wrap="">I have taken the consultant and tradesperson trainings in Passive
House. The key element for a warm winter house and cool summer house
are overhangs that shade in the summer when the sun is at a higher
angle yet don't obstruct the sun in the winter.
The house is built like a thermos so it does not swing with outdoor
temperatures BUT if heat enters it via the windows it has nowhere to
go.

Gennaro Brooks-Church
Director, Eco Brooklyn Inc.
Cell: 1 347 244 3016 USA
<a class="moz-txt-link-abbreviated" href="http://www.EcoBrooklyn.com">www.EcoBrooklyn.com</a>
22 2nd St; Brooklyn, NY 11231


On Wed, Aug 15, 2012 at 11:43 AM, Matt Dirksen <a class="moz-txt-link-rfc2396E" href="mailto:dirksengreen@gmail.com"><dirksengreen@gmail.com></a> wrote:
</pre>
      <blockquote type="cite">
        <pre wrap="">I've certainly read up on Passivehaus over the years, but this article (and
other’s I’ve read) make me wonder how one designs these homes to properly
accommodate for potential of overheating – especially during peak loads?



I am curious how it was determined that a house is considered "overheating"
when it surpasses 77 degrees ten percent of the year? Is that during
daylight hours or a 24 hour period? Because the reality is, if one’s house
overheats for up to a third of the Summer, I’d expect some serious
complaints to arise.



In other words: does PH actually design for the anticipation of a 10+ person
summer birthday party which happens to land in the middle of a heat/humidity
wave?



It would seem to me that a “dumb-ole” back up air conditioner would still be
required for events like this no matter what. But if that’s the case,
wouldn’t that count against the 4.75 kbtu/h measurement?



Obviously I am seeking more enlightenment on this subject, but the “data”
simply hasn’t eased my skepticism yet.



Thanks,



Matt


On Wed, Aug 15, 2012 at 10:39 AM, John Straube <a class="moz-txt-link-rfc2396E" href="mailto:john@buildingscience.com"><john@buildingscience.com></a>
wrote:
</pre>
        <blockquote type="cite">
          <pre wrap="">
I have mentioned the challenge of high SHGC windows in super insulated
homes (eg Passiv Haus) previously

A recent article from Maine -you know, that hot humid place in summer :) -
is yet another story I have heard on this issue.

A really good builder with some experience in PH renovated his own home.
The article is at coastalcontractor.net

To quote the relevant parts:
"“We're very close to the Passive House new construction standard from an
annual heating load standpoint," says Corson. “Instead of 4.75 kBTUs/sqft,
we've got this house down to about 6 kBTUs/sqft. And the peak load in this
house is down to about 10,000 BTUs an hour — which for Maine, is pretty
low." Oddly enough for a house in the frozen North, however, it's the summer
issues that are now the most vexing. “I need to address shading of the
windows, the cooling load, and summer dehumidification," says Corson.

“Getting this house so close to Passive House, and living here in the
summer, has really given me a sense of the propensity for overheating," says
Corson. “The windows I used on this house have a solar heat gain coefficient
of .494, the same as the windows we used on the Knox job. For the new house
in Montville that we're doing now, we used a .62 solar heat gain unit — much
higher. If I had used the .62 solar heat gain window on this house, we would
be well below passive house standards for our annual heating demand (though
not necessarily for our shell airtightness). But in the summer — we'd be
baking in here right now."

.....

The Passive House standard says a house isn't overheated unless the indoor
temperature exceeds 77°F for more than 10% of the year, Corson explains.
“Theoretically, on paper, in the PHPP, the house that we're living in now is
not overheating," he says. "

Short summary: in super insulated homes high SHGC may look good on paper
for the solar gain they give in the middle of winter, but hourly spring/fall
peaks of gain can cause real discomfort.  Most programs cant reliably
predict this.  High SHGC makes sense with really low window areas, but not
with the window area people usually want for view and daylight.


--
Dr John Straube, P.Eng.
Building Science Corporation
Westford MA Waterloo ON

<a class="moz-txt-link-abbreviated" href="http://www.BuildingScience.com">www.BuildingScience.com</a>

_______________________________________________
Greenbuilding mailing list
to Send a Message to the list, use the email address
<a class="moz-txt-link-abbreviated" href="mailto:Greenbuilding@bioenergylists.org">Greenbuilding@bioenergylists.org</a>

to UNSUBSCRIBE or Change your List Settings use the web page

<a class="moz-txt-link-freetext" href="http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org">http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org</a>
</pre>
        </blockquote>
        <pre wrap="">


_______________________________________________
Greenbuilding mailing list
to Send a Message to the list, use the email address
<a class="moz-txt-link-abbreviated" href="mailto:Greenbuilding@bioenergylists.org">Greenbuilding@bioenergylists.org</a>

to UNSUBSCRIBE or Change your List Settings use the web page
<a class="moz-txt-link-freetext" href="http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org">http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org</a>
</pre>
      </blockquote>
      <pre wrap="">
_______________________________________________
Greenbuilding mailing list
to Send a Message to the list, use the email address
<a class="moz-txt-link-abbreviated" href="mailto:Greenbuilding@bioenergylists.org">Greenbuilding@bioenergylists.org</a>

to UNSUBSCRIBE or Change your List Settings use the web page
<a class="moz-txt-link-freetext" href="http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org">http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org</a>
.

</pre>
    </blockquote>
    <br>
  </body>
</html>