<p>Thanks RT,<br>
I think removing the lathe and sheething (saving the sheething for reinstallation or another use) and placing insulation between the studs is a good idea. If we don't reinstall the sheething we would need to install some other sheer bracing (the sheething boards vary in width from 8" to 30" and material including cherry, poplar and butter nut).<br>

What about air sealing? Trying to seal the existing sheething would be difficult to say the least. Would the gypsum plaster be adequate?</p>
<p>Sam <br>
On Jun 13, 2013 8:37 PM, "RT" <<a href="mailto:archilogic@yahoo.ca">archilogic@yahoo.ca</a>> wrote:<br>
><br>
> On Thu, 13 Jun 2013 20:12:58 -0400, Sam Ewbank <<a href="mailto:g.l.ewbank@gmail.com">g.l.ewbank@gmail.com</a>> wrote:<br>
><br>
>> I'd worry about the cellulose being packed up against the brick then getting wet and setting due to moisture migration.<br>
><br>
><br>
>> Another would be installing rockwool batts between the studs and then a<br>
>> rigid insulation in place of the sheething.<br>
><br>
><br>
>> The owners are planning to eventually install gypsum plaster as the<br>
>> finished wall covering.<br>
><br>
><br>
> Roxul (rock wool) Drainboard can be used in what is typically the one inch air space behind brick veneers.<br>
><br>
> Oftentimes mortar droppings clog the air space rendering it ineffective at its intended task so the installation of Roxul in that space eliminates that possibility while still allowing drainage to take place. (WatJohn did a paper on the topic when he was still a student IIRC).<br>

><br>
> If removing the wood lath and plank sheathing is an option, then installing Roxul batts would be a very good option, I think ... especially if the planks can be salvaged.<br>
><br>
> -- <br>
> === * ===<br>
> Rob Tom                                 AOD257<br>
> Kanata, Ontario, Canada<br>
><br>
> < A r c h i L o g i c  at  Y a h o o  dot  c a  ><br>
> (manually winnow the chaff from my edress if you hit "reply")<br>
><br>
><br>
> _______________________________________________<br>
> Greenbuilding mailing list<br>
> to Send a Message to the list, use the email address<br>
> <a href="mailto:Greenbuilding@bioenergylists.org">Greenbuilding@bioenergylists.org</a><br>
><br>
> to UNSUBSCRIBE or Change your List Settings use the web page<br>
> <a href="http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org">http://lists.bioenergylists.org/mailman/listinfo/greenbuilding_lists.bioenergylists.org</a><br>
</p>