<div dir="ltr"><div>I understand that it is possible with thick walls (10-1/4" in my case) to find oneself unable to achieve a dense pack if the cavities are too wide/one doesn't create enough baffles. In the case at hand I am in the process of building a double wall (2x6 load-bearing interior, 2x4 ~Larssen truss exterior) with about an inch and a quarter gap between the two walls. The cavities are between 40 and 60 inches tall and 10-1/4" thick if as I intend to I staple mesh across those narrow gaps. Is this adequate? Or should I staple mesh <u><i>between </i></u>the interior and exterior wall assemblies and figure out a way to blow cellulose into each separately? Comments and suggestions very welcome. <br>
<br></div>Thanks very much.<br></div>