<div dir="ltr"><div><div><div><div><div><div><div>The situation is as follows: <br>a ceiling with 7-1/4"x14" bays, 11 feet deep<br></div>car decking below, fir T&G flooring above, rough sawn 2x8s in between. <br><br></div>I can get Rockwool/Roxul batts that are the right height and will figure out a way to trim them to the right width. My question is whether anyone has a suggestion about how to devise a sleeve or baffle to reduce the considerable friction all those rough sawn or at least not particularly smooth surfaces will present to the batts being shoved horizontally through those bays? <br></div>I expect to be able to access both ends for this purpose, which should increase the options for friction-reducing aids. <br><br></div>Any ideas?<br><br></div>Thanks very much.<br><br></div>Reuben<br><br></div>Oh, and I nixed the blown in cellulose idea because of the challenges of creating the necessary back pressure on a bay that deep/long. I'm sure with a suitably devised baffle that I could gradually back out the nozzle & this problem could be overcome, but it is not a large job (11'x12') and the batts seemed easier.<br></div>