<div>I see Paul Oliver's work to be excellent and appreciate how a variable speed fan can offer excellent control over TLUD operation. My reservation is that there are many places where even the small power requirement (Paul says 1-2 watts) just isn't available. Lots of people here in Nicaragua are totally off-grid and don't have reasonable access to a way to charge a battery. So, I am been thinking about options. Being, among other things, an electronics geek, here is what I have been thinking about.<br clear="all">
</div><div><br></div><div>Running the TLUD 8 hours a day at "average" fan speed means 12 watts per day. At 12 volts that's one ampere hour. I have been thinking about a couple of approaches. One is "higher tech" but may be a better solution at an equivalent or lower cost. In both cases I am just thinking of a photovoltaic panel to charge the battery. The difference is the battery voltage.</div>
<div><br></div><div>Small PV panels are pretty common on the surplus market. For example, Electronic Gold Mine (<a href="http://www.goldmine-elec.com/">http://www.goldmine-elec.com/</a>) offers an assortment. The specifications vary from 7 to 35 volts open circuit with output power in the range of 1-3 watts. Prices are from $4.50 to $15. As this is quantity one retail price information, it is likely the could be found at significantly lower costs.<br>
</div><div><br></div><div>As any PV-based system will need some sort of charge controller for the battery and what PV cells (in particular, what voltage) will be available at the best price point, I am thinking that using a single-cell Lithium Ion battery (3.7 volts nominal) would make the most sense. Units with a capacity of 2.2 ampere hours and more are commonly used in laptop computers. They offer reasonable life, low cost and the possibility of finding them on the surplus market. The cells can be paralleled if higher capacity is needed.</div>
<div><br></div><div>A switching "up-converter" would be needed to supply the 12 volts needed for the fan. The speed control could be incorporated into the up converter which would reduce the cost and increase the efficiency. </div>
<div><br></div><div>The alternative would be to use a more or less 12 volt battery (three Li-Ion cells in series) so that the up-converter could be eliminated. My initial guess is that the reduced electronics cost would not be as much as the increased battery cost but it is a viable alternative as long as higher voltage surplus PV panels are available.</div>
<div><br></div><div>While this sounds like a lot of electronics, this is all very common stuff that you find in, for example, cellular phones. There is some design work needed but the actual component costs will be very low. </div>
<div><br></div><div>Comments? <br></div>-- <br>Phil Hughes <br><a href="mailto:nicafyl@gmail.com">nicafyl@gmail.com</a><br><br><br><br><br>