<br><br><div class="gmail_quote">On 25 October 2012 11:59, Alex English <span dir="ltr"><<a href="mailto:english@kingston.net" target="_blank">english@kingston.net</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">

  
    
  
  <div bgcolor="#FFFFFF" text="#000000">
    <div>Stovers,<br>
      One of my first TLUDs , in the pre modern era, was made with a
      combination of milk can and propane cylinder. I would remove the
      valve and fill with water and cut with a angle grinder until I had
      a vent opening to adequately release any over pressures due to
      rapid ignitions. Detonations are another matter. When cutting with
      acetylene and oxygen, if you momentarily snub the torch and
      extinguish the flame the gasses can fill a closed container and
      then ignite on an ember with dangerous yield. Almost "blew-it" a
      few weeks ago when lighting a Dasifier. Ka bang! Of the three
      accidents that week, that was the one I didn't end up in ER for. <br></div></div></blockquote><div><br><br>I plasma cut them with no problems. Fill with water and bleach solution (destroys the mercaptans), drain and cut with 20,000 degree gas <br>
<br>Steve <br></div></div>