<div dir="ltr"><div>Hello Jock et al;</div><div><br></div><div>I have had a go with the two washers method, without the copper pipe in between them.  What I observed was that some of the flames came up the sides and didn't mix well.  So what I did was put the a concentrator lid back on (See attached photo). Now what I have is:</div>
<div><br></div><div>1) top washer in the chimney</div><div>2) concentrator disk</div><div>3) bottom washer below the secondary air jets, but above the fuel bed.</div><div><br></div><div>With the concentrator disk, the flames are forced into the middle as before, where there is mixing, but then forced apart again as they pass the upper disk. </div>
<div><br></div><div>What concerns, me though is that the increased resistance to air flow has reduced the power output from the stove.</div><div><br></div><div>Tomorrow, I will run some reps with and without the gas wick gizmo to measure the rate of fuel consumption.</div>
<div><br></div><div>Cheers,</div><div>Julien<br clear="all"><br>-- <br></div><div dir="ltr">Julien Winter<br>Cobourg, ON, CANADA<br></div>
</div>