<div dir="ltr"><div>Dear all,<br></div><div><br></div><div>Yesterday I repeated an experiment that i did some time ago:</div><div><br></div><div>I used my TLUD stove at lunch time for 40 minutes approximately. Then, when i finished the cooking tasks (boiling water, etc.), I turned off the stove, closing the primary air control and covering the top of the stove (after removing the burner).</div>
<div><br></div><div>Then, 5 hours later, i could restart the stove without touching the remaining fuel of the first run. Before, I checked that at the bottom remains some unburned pellets.</div><div><br></div><div>I put some alcohol on the char and start the fire again. I use a chimney of 30-35 cm tall, and the primary air control full open.</div>
<div>After a few minutes, the secondary flame extinguished. Then i blowed some air into the primary air opening, and the seconday flame appears again (blue flame).</div><div><br></div><div>Finally, after 10 minutes or less in gasification mode, sufficient heat reached the unburned pellets and the stove start again to operate like a "normal" TLUD stove (pyrolysis mode).</div>
<div><br></div><div>The stove continued the run for 10 or 15 minutes more in pyrolysis mode, sufficient to boil 1 liter of water, for example.</div><div><br></div><div>With this experiment, i could demostrate that you can use the TLUD stove at different times with only one load of pellets.</div>
<div><br></div><div>I thing that i could relight the stove, because the burner i use can burn the gases in gasification mode.</div><div><br></div><div>Greetings<br>Roberto Poehlman</div><div>Valdivia, Chile</div>
</div>