<div dir="ltr"><div>Hi Paul and all;</div><div><br></div><div>I am glad you found my talk informative.  I have been meaning to post a description of the slides to "the list," but I have been too busy frying other pelicans.  Today, I am flogging a proposal for a nut tree park and permaculture community garden.</div><div><br></div><div>The experiment I conducted was to the look at the range of maximum fuel bed temperatures in a natural draft, top-lit updraft gasifier.</div><div><br></div><div>The primary are was fixed for each run by fitting a grate with a set aperture.</div><div>Temperature was measured every 5 seconds in the center of the fuel bed at 5, 10, 15, and 20 cm above the grate.  The maximum temperature was recorded and averaged for all four thermocouples.  Most of the time, the maximum temperature occurred as the moving pyrolytic front arrived at the thermocouple, but in some cases it occurred several minutes later.   </div><div><br></div><div>The average gasification rate was determined by measuring the amount of fuel dry-matter lost between lighting the top, and the end of fuel pyrolysis.  No correction was made for the lag at start-up, nor slowing down at the end, because measurements of mass loss over time showed that these periods were not very long.</div><div><br></div><div>Gasification was expressed as g-dry matter lost, per meter squared of TLUD cross-sectional area, per second.</div><div><br></div><div>In the final slides were temperature is plotted against gasification rate, each point is an independent observation (complete run of the reactor).  Some of the points appear as two 'eyes'.  That is because they are a pairs of replicated runs.</div><div><br></div><div>I will write a description for the slides in the presentation in a day or two.</div><div><br></div><div>All the best,</div><div>Julien.<br clear="all"></div><div><br></div><div><br>-- <br></div><div class="gmail_signature"><div dir="ltr">Julien Winter<br>Cobourg, ON, CANADA<br></div></div>
</div>