<div dir="ltr">Hi Rolf,<div><br></div><div>The 55 gallon TLUD kept going when using very dry heating stove pellets. If your fuels go out I think that adding more air, both primary and secondary, could help.</div><div><br></div><div>Best of luck,</div><div><br></div><div>Dean</div></div><div class="gmail_extra"><br><div class="gmail_quote">On Sat, May 16, 2015 at 4:35 AM, Energies Naturals C.B. <span dir="ltr"><<a href="mailto:energiesnaturals@gmx.de" target="_blank">energiesnaturals@gmx.de</a>></span> wrote:<br><blockquote class="gmail_quote" style="margin:0 0 0 .8ex;border-left:1px #ccc solid;padding-left:1ex">AJH,Alex,Crispin,Dean and all the others,<br>
<br>
thanks an awful lot for these good examples and practical advice on big TLUDs.<br>
I always thought that the granulometry matters a lot as for the max size of a<br>
gasifier, but from Bill's 350 gal  experience I see it doesn't !<br>
His shells are much the size of our almond shells and even with more dust particles among them.<br>
<br>
Now I am looking for a long gas tank and build one myself. I was always trying to have something "inexpensive"<br>
which allows me to use the energy delivered during the pyrolisis for heating and other purposes and not waste it.<br>
<br>
And I'll try to run it on big chunks of 120 mm length from our old Jensen chopper which has by far the best<br>
ratio diesel/chopped brushwood I know of.<br>
I can also try the G 50 chipps made with a Laimet screw chipper and other G 30 from a modern Jensen disc chipper.<br>
If the old Jensen's chipps would work, that would be marvellous!<br>
<br>
I'll let you know.<br>
<br>
Rolf<br>
<br>
<br>
<br>
<br>
<br>
<br>
On Thu, 14 May 2015 22:35:04 +0100<br>
<a href="mailto:ajheggie@gmail.com">ajheggie@gmail.com</a> wrote:<br>
<br>
> [Default] On Thu, 14 May 2015 15:44:58 -0400,Crispin Pemberton-Pigott<br>
> <<a href="mailto:crispinpigott@outlook.com">crispinpigott@outlook.com</a>> wrote:<br>
><br>
> >A related question for Tom Miles:<br>
> >What do you think of the possibility of running a steam stream into a TLUD<br>
> >with the primary air to pass water vapour into the pyrolysis zone to create,<br>
> >at a lower temperature, H2 and CO. This will have the effect of decreasing<br>
> >the heat available in the fuel bed and increase the CV of the gas produced.<br>
><br>
> If I may butt in; this water gas reaction depends on the steam meeting<br>
> with hot char at above 800C to convert most of the water, it is highly<br>
> endothermic, so I doubt the descending pyrolysis front is hot enough<br>
> and even if it were the endothermy and small mass of hot char would<br>
> very quickly quench the reaction.<br>
><br>
> >This effect was accomplished by spraying water onto the hot coals in a coal<br>
> >gas plant. It reduced the temperature of the working environment and<br>
> >increased the CV of the "town gas".<br>
><br>
> Yes but the mass of hot coke (and probably the brick lining plus the<br>
> fact the steam was superheated made the reaction possible for a while,<br>
> then the coals cooled and the  steam was shut off whilst the coals<br>
> were blasted with air to give a CO and N2 mix, this being endothermic<br>
> took the mass back up to above 1100C., The CO+N" at 1100C was then<br>
> burned separately to raise steam and repeat the process. This way the<br>
> output was H2 and CO nearly free of N2.<br>
><br>
> AJH<br>
><br>
> _______________________________________________<br>
> Stoves mailing list<br>
><br>
> to Send a Message to the list, use the email address<br>
> <a href="mailto:stoves@lists.bioenergylists.org">stoves@lists.bioenergylists.org</a><br>
><br>
> to UNSUBSCRIBE or Change your List Settings use the web page<br>
> <a href="http://lists.bioenergylists.org/mailman/listinfo/stoves_lists.bioenergylists.org" target="_blank">http://lists.bioenergylists.org/mailman/listinfo/stoves_lists.bioenergylists.org</a><br>
><br>
> for more Biomass Cooking Stoves,  News and Information see our web site:<br>
> <a href="http://stoves.bioenergylists.org/" target="_blank">http://stoves.bioenergylists.org/</a><br>
><br>
<br>
<br>
--<br>
Energies Naturals C.B. <<a href="mailto:energiesnaturals@gmx.de">energiesnaturals@gmx.de</a>><br>
<br>
_______________________________________________<br>
Stoves mailing list<br>
<br>
to Send a Message to the list, use the email address<br>
<a href="mailto:stoves@lists.bioenergylists.org">stoves@lists.bioenergylists.org</a><br>
<br>
to UNSUBSCRIBE or Change your List Settings use the web page<br>
<a href="http://lists.bioenergylists.org/mailman/listinfo/stoves_lists.bioenergylists.org" target="_blank">http://lists.bioenergylists.org/mailman/listinfo/stoves_lists.bioenergylists.org</a><br>
<br>
for more Biomass Cooking Stoves,  News and Information see our web site:<br>
<a href="http://stoves.bioenergylists.org/" target="_blank">http://stoves.bioenergylists.org/</a><br>
<br>
</blockquote></div><br></div>