<div dir="ltr"><div><div>Dear Roberto;<br><br></div>Thanks for the video.  That is an interesting idea for a burner.<br><br><br></div><div>I have found that it is a good idea to test a burner over a wide range of gasification rates, because the patterns of air/fuel mixing and ratio can change quite bit.<br><br></div><div>It would be interesting to see how well your burner turns down.  You may find that there is a point in the pyrogas supply rate between very low, and medium where the burner becomes a bit smokey, because there is not quite enough secondary air from the lower holes, but secondary air arriving above the concentrator ring is arriving too late, and/or not mixing in properly.  <br><br></div><div>I once designed a burner that had a nice blueish flame but only in a narrow range of gasification rates.  Another burner I have used a lot shows a shift between the flame dancing over the top of the char bed at low gasification rates, to a flame originating from the secondary air holes.  Between these two modes, there is a narrow zone in gasification rate where neither mode is optimal.<br></div><div><br></div><div>At high gasification rates, you have a tall flame.  Is it possible for you to increase the width of the burner to allow more horizontal space for the flame?<br><br></div><div>A question that I have been meaning to read-up on is the relative strength of Venturi effects at the speed of air flow that we have in TLUDs, and the pressure differential generated by draft.  My gut feeling is that the Venturi effect is not quite as important as we might think, and that the effects we see are largely driven by draft.  I am sure someone is going to have something to say about that.<br><br></div><div>You have presented some through-provoking ideas.  Thanks for sharing.<br><br></div><div>Cheers,<br></div><div>Julien.    <br></div><div><div><div><br>-- <br><div class="gmail_signature"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr">Julien Winter<br>Cobourg, ON, CANADA<br></div></div></div></div></div></div>
</div></div></div></div>