<div dir="ltr"><div>Hi all;<br><br></div>Here is an interesting article about inverse diffusion flames IDF similar to what we see in many TLUDs:<br><br>Blevins, L. G., Yang, N. Y., Mulholland, G. W., Davis, R. W., & Steel, E. B. 2002. Early soot from inverse diffusion flames. Prepr. Pap.-Amer. Chem. Soc., DiV. Fuel Chem, 47(2), 740-741. <br clear="all"><div><div><br><a href="https://web.anl.gov/PCS/acsfuel/preprint%20archive/Files/47_2_Boston_10-02_0236.pdf">https://web.anl.gov/PCS/acsfuel/preprint%20archive/Files/47_2_Boston_10-02_0236.pdf</a><br><br></div><div>I have attached a photo of standard diffusion flame and an IDF of ethylene flames near their sooting limits. (Kumfer, BM; Skeen, SA; Axelbaum, RL.  2008.  Soot inception limits in 
laminar diffusion flames with application to oxy-fuel combustion.  
Combustion and Flame 154; 546-556)<br><img alt="Inline image 1" src="cid:ii_1535318196a0f4b0" height="440" width="305"><br></div><div><br></div><div><br><br><br>In her article, Linda Blevins argues that soot forms on the outside edge of an IDF, then follows a trajectory away from the flame, and escapes oxidation.  In a standard diffusion flame, soot tends to be oxidized in the tip of the flame.<br></div><div><br>One common type of syngas burner for TLUDs has secondary air entering the gas burner through small holes.  The flamelets arrising from these holes start out as a type of IDF.  Syngas rises from below, so the underside of the flamelets should be more fuel rich than the top side (which may be lean).  Therefore, soot production in a TLUD burner should be greatest on the underside of the flamelets.  If the flamlets coaless to form a sheet of flame across the width of the gas burner, then (most?) soot particles will have to pass through this flame and oxidized to varying degrees.<br><br>However, if we turn down the gasification rate in the TLUD, so there is not a continuous sheet of flame across the width of the burner, is there a change in the nature of soot particles in the exhause gas from the stove?  Will there be a higher proportion of polycyclic aromatic hydrocarbons vs black carbon from a turned down TLUD?  Of course, when turned down the mass of soot emitted may not be very high.  All the same, this is an example of why we should characterize emissions from stoves over a wide range of power levels when assessing health risks.<br><br></div><div>Cheers,<br></div><div>Julien. <br></div><div><br><br></div><div><br>-- <br><div class="gmail_signature"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr">Julien Winter<br>Cobourg, ON, CANADA<br></div></div></div></div></div></div>
</div></div></div>