<div dir="ltr"><div>Paul,</div><div>You asked what I might be able to do to shed light on the conditions for achieving a blue flame.</div><div><br></div><div>This week I followed the evidence. It was clear from running a TLUD at higher temperatures that the flame behaved differently than my original example. The flame speed of the mix could attach at the point of secondary air entrance in a 2 inch pipe ( all measures are inside diameter). Reducing this to 1.5 inches moved the flame up to the transition back to 2 inches. The flame speed was two slow for the higher speed in the 1.5 inch pipe. However the 1.5 inch section was six inches long and it was clear that the flame was not very well premixed because of tall orangey tails extending from the lower blueish portion.  So a few increments of changes later  the burner now has 18 inch mixing tube between the secondary air introduction and the point of flame attachment. It steps down from 2 to1.5 to 1.25 and up again to 1.5 to 2 to 2.5 which is the cone that expands to 6 inches.</div><div><br></div><div>This is the result;</div><div><a href="https://www.youtube.com/watch?v=5sjOTHwDsWo">https://www.youtube.com/watch?v=5sjOTHwDsWo</a><br></div><div><br></div><div><i>It is quite different than the origional  slow continuous blueming flame flower </i></div><div><i>Here again</i></div><div><i><a href="https://www.youtube.com/watch?v=jnV1e60NTss">https://www.youtube.com/watch?v=jnV1e60NTss</a><br></i></div><div><i><br></i></div><div><i>There are a differences that are due to the fuel gasses, the temperature of the gasses and perhaps the excess air values. All play a role. </i></div><div><i>The much longer mixing tube changes the net draft as well. Also I was unable to light the mix from the secondary air entrance. Had to be lit top- down.</i></div><div><br></div><div>Here is a fun ignition shot. Talk about descending flame fronts:)</div><a href="https://www.youtube.com/watch?v=X7JepJ1MdWg">https://www.youtube.com/watch?v=X7JepJ1MdWg</a><br><div><br></div><div>You tube has a 'gear' icon in the lower right of the screen where you can control the speed of the video replay (without sound). It is informative to watch these at .25 speed. The glowing meteor sparks show up better. Starting and stopping the videos freeze them in there tracks. If one knew the frame speed of the camera you could almost calculate the velocity of the sparks by the length of their paths.</div><div><br></div><div>Sorry to interrupt the very interesting discussion of charcoal.</div><div>Alex</div></div>