<div dir="ltr"><div>Paul,</div><div>Lacking anything like data backed proof of down-drafting  in these little stoves without fans. I say no way.</div><div><br></div>Buoyancy in chimneys and stoves is often visualized as something like gasses, being sucked up. It is really gasses being pushed up by heavier gasses being sucked down by by gravity more like water seeking it own level and forcing air above it. Inside a top lit stove of pellets the air in the bottom is cold and heavy. It is pushed up to replace the lighter hot gasses above. Edge of container  effects may cause small eddies. If it is cooler than the hot middle then a bit of down movement but not much. As the container heats up it may be hotter than the cool pellets in the middle. Then there would be a little movement up near the edge. The end result in a TLUD is a fire or front (MPF) that in fact seeks its own level.  <div><br></div><div>I have operated  Paul brand TLUD in a painted cylinder filled with pellets so slowly that the pellets at the edge were torrified and the rest were charred and the paint was still good.  I have operated pellets at 18 inches in diameter , 40 inches deep for up to a continuous burn of 12 hours. I have also operated continuous down drafters for days but needed a hot 10 feet of chimney to over come buoyancy in a two inch diameter burner. </div><div><br></div><div>There's no pressure gradient to drive this fantasy in the real world.</div><div><br></div><div>Ah there's Hugh now....driving his own spike.</div><div><br></div><div>Done</div><div><br></div><div>Alex</div></div>