<div dir="auto">Hello Stovers! </div><div dir="auto"><br></div><div dir="auto">This is my latest stove which is much simpler and cheaper ($25 plus free 5 gallon metal bucket) to make than my previous versions and it also uses non pre heated tertiary air.  It’s so easy to re light without having to stick a lighter into the combustion chamber. The most interesting part was the Extremely steady flame during start up.  </div><div dir="auto"><br><div dir="auto">Start up Video -<a href="https://youtu.be/9J3CInnifAk">https://youtu.be/9J3CInnifAk</a></div></div><div dir="auto"><br></div><div dir="auto">In the video I’ve given as much information as I could.  </div><div dir="auto"><br></div><div dir="auto"><div>Stove Operation after 1 hour - <a href="https://youtu.be/z1VmlJIaA34">https://youtu.be/z1VmlJIaA34</a></div><br></div><div dir="auto">Just after the video the stove went out because of an over fire situation caused by poor design of the fuel chamber.  The fuel burned down my 3” pipe and straight to the bottom.  When I removed the cover almost no pellets burned on top of the fuel bed outside of the 3” pipe which extended about 6 inches into the pellet fuel. This means the stove barely had any preheated air.  I’ll update tomorrow after I attempt some quick fixes and fresh ideas.  </div><div dir="auto"><br></div><div dir="auto"><br></div><div dir="auto"><br></div>