<div dir="ltr"><div dir="ltr"><div>Hi Chrispin;</div><div><br></div><div>The pulsing I observed is with concentrator rings on a 7-inch diameter TLUD.  The concentrators are about 6 cm above the top level of the pellet fuel.   The fuel bed is 10 cm deep.   The pulsing occurs with the narrowest aperture concentrators (25-50% TLUD reactor diameter), from moderately low to highest primary air, and during the entire gasification until the ignition front hits the grate, and we start to approach flame-out.</div><div><br></div><div>At first I thought that the oscillations may be pressure build-up, below the concentrator (or nozzle), because the pathways for preheated secondary air and primary air will have buoyancy and momentum.  The pathways also have resistance: the secondary air is up a narrow 1/2 inch gap between concentric cylinders of the TLUD, and the primary air flow faces resistance at the regulator and in the fuel bed.</div><div><br></div><div>I thought that perhaps I was getting some pressure build-up below the concentrator or nozzle throats, like the inner chamber of a rocket engine.  I was even thinking we should rename TLUDs to 'rocket stoves.'</div><div><br></div><div>Then, I lifted the nozzle off the TLUD to create a gap that would allow for pressure release.  The pulsing was unchanged.</div><div><br></div><div>It will be a couple of weeks before I can get a video of the pulsing, because my gear is doing other duties at the moment.  I will also summarize my observations, because  I recorded the frequency of pulsing for the different treatments (following Ron Larson's advice).</div><div><br></div><div>Cheers,</div><div>Julien</div><div><br></div><br>-- <br><div class="gmail_signature" dir="ltr"><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr">Julien Winter<br>Cobourg, ON, CANADA<br></div></div></div></div></div></div></div></div>